Q-Logic Router 9120 Manuale Utente

[ Quick Start Guide ]QUICK START GUIDESilverStorm™ 9120 INSTALLATION d

8Step 2. Check that the CD has been mounted. Type ls /mnt/cdrom.The system returns a list of files on the CD.Step 3. Create a subdirectory on the driv

9Declaration of ConformityQLogic Corporation.26650 Aliso Viejo ParkwayAliso Viejo, CA 92656Phone: 949.389.6000www.qlogic.comQLogic Corporation declare

10

© 2007 QLogic Corporation. QLogic, the QLogic logo, the Powered by QLogic logo, SANbox, SANsurfer, and SANsurferManagement Suite are registered tradem

JQLogic Corporation 26650 Aliso Viejo Parkway Aliso Viejo, CA 92656949.389.6000 www.qlogic.comD000010-002 Rev. A

Purchasers of OEM products should consult with the OEM for support.Support Headquarters QLogic Corporation4601 Dean Lakes BlvdShakopee, MN 55379QLogic

1SilverStorm 9120 Quick Start GuidePre-Installation ChecklistBefore beginning the actual installation, the Site Implementation Engineer must perform t

2❑ Release Notes.Step 2. Unpack the equipment.Step 3. Inspect the equipment for any shipping damage. NOTE: Any shipping damage should be reported to t

3Installation TasksNOTE: Before performing the installation tasks, take a few minutes to review the figures below. It is important to understand the s

4To perform the actual switch installation, the site implementation engineer must perform the following tasks, which are detailed in this section.Step

5❑ Flow control = XON/XOFFStep 2. Power up the switch.Step 3. To change the switch default IP address enter:setChassisIpAddr -h ipaddress -m netMaskwh

6where -h ipaddress is the new IP address in dotted decimal (i.e., xxx.xxx.xxx.xxx) format, and -m netMask is the new subnet mask in dotted decimal (i

7Step 5. Type in the new switch IP address.Step 6. Type in the new net mask.Step 7. Click Apply.Step 8. To change the switch default gateway, from the